![]() ToolRev earns commissions on purchases made through our links. That said, if you want a next-level multi-tool that cuts like a reciprocating saw check out the new Milwaukee M18 FUEL 2836-20. It’s one of the most versatile tools out there, and Milwaukee recently upped the ante by adding FUEL versions of its OMT offerings, in both M12 and M18 versions. Customer reviews 4. The Makita’s larger size, weight and missing work light put in a distant third place. Of the three tested here, the Milwaukee 2626 had the best grip and was the easiest to control, but I prefer the DeWalt for its quick blade change and lighter weight. Even so, I would use universal blades on all three models because they install faster than closed end blades. Are you looking for a guide on Milwaukee M18 vs M18 Fuel range. Read honest and unbiased product reviews from our users. On amazon I can get the m18 with 1. Also at HD (If and when they restock) I can get the m18 (Non-fuel version) multi tool for 99. Meanwhile, the Makita and Milwaukee take each other’s accessories, as well as universal blades, with no adaptor needed. Find helpful customer reviews and review ratings for Milwaukee M18 FUEL Oscillating Multi-Tool - No Charger, No Battery, Bare Tool Only at . At HD I can get the m12 multi tool with a free battery for 150. Oddly, the adaptor ring that comes with the DeWalt does not line up with Makita, Milwaukee, or Bosch accessories. All three models have a tool-less blade change: The Milwaukee and Makita use a lever and pin system, where the DeWalt uses a much faster quick-release mechanism. The DeWalt uses universal, open end type, accessories available from DeWalt, Dremel, Rockwell and others. The newer DSC356 has a 3 speed selector switch that locks into high at each of the three settings. ![]() The POWERSTATE Brushless Motor delivers 10,000 to 20,000 OPM, with an aggressive 4. The trigger goes from 0-20k oscillations/minute which, when brought up to full speed, can be locked on high with the trigger itself being the release. The MILWAUKEE® M18 FUEL Multi-Tool generates fast cuts, the power for demolition, and low full tool vibration. ![]() The Dewalt has a variable speed trigger and no on/off switch. The dial can be set from 11-18k oscillations per minute on the Milwaukee and from 6-20k on the Makita. The Milwaukee and Makita use an on/off switch and a variable speed dial. This unit is an absolute beast My dad in law has a Dewalt 12v version (Im not doing the yellow vs red thing today) for comparison. The weights listed above are with a five amp hour battery attached. Vibration is pretty even across the board, unless you hold the DeWalt by the pistol grip, in which case it has more vibration than the others, but still good. And all of the cordless units were close enough to the corded Makita to justify ditching the cord.Īll of the tools are extremely loud. The corded Makita was faster through 1×8” beveled pine. ![]() The Milwaukee took first place in the three nail test. Using fully charged five amp hour batteries and new Dremel carbide multi-tips all of the tools performed to within a second or two of each other. ![]()
0 Comments
Leave a Reply. |